- 5, NIVEL , TEMPERATURA Y TURBIEDAD DEL AGUA DEL RIO
5.1 Equipo:
- 3 Piezómetros modelo Soilints Serie: 1053975,1053942,1053966
- 1 Piezometro Barologer Serie 20051391
- 1 Sensor laser de temperatura superficial serie
- Garmin OREGON 550 Serie 1MW061860
- Lectora de Piezometros, Computadora con software 1 Machete.
- Turbidimetro WQ 770 Serie: 100199594
- Cinta de 2 metros.
1.2. Actividades
Con el objeto de conocer el nivel del agua y la temperatura del agua durante toda la prueba se instalar 3 piezómetros a un nivel promedio de la profundidad del agua a una margen del Rio Pacora. Estos tres piezómetros almacenaran los datos por espacio de 15 minutos y se almacenara los datos en un dataloger del equipo. Se deberá tomar el nivel del agua (H) donde se ubica el sensor y colocar el sensor a una H/2 la cual no debería ser menor de 0.30 centímetros. El punto donde se ubica el sensor será localizado con la estación total, la cual le dará coordenadas X, Y ; además de la elevación del punto. Los piezómetros deben ser identificados con los códigos S1, S2 y S3 todos a la margen derecha del rio. La temperatura medida será comparada con la temperatura que registra el bote a la hora que se realice el aforo por el bote.
Se registrarán las condiciones de temperatura superficial del agua del rio, la turbiedad del agua y la localización del punto en coordenadas UTM en el momento y hora del muestreo.
In order to know the water level and water temperature throughout the test three piezometers were installed to an average depth of the water at a river bank Pacora. These three piezometers store data for 15 minutes and the data was stored in a team dataloger. It will take the water level (H) which houses the sensor and place the sensor at a H / 2 which should not be less than 0.30 inches. The point where this sensor is located with the total station, which will give coordinates X, Y, besides the point elevation. The piezometers should be identified with codes S1, S2 and S3 all to the right bank of the river. The measured temperature is compared with the temperature measured at the pot when the capacity is made by the boat.
Conditions were recorded surface water temperature of the river water turbidity and point location in UTM coordinates and time at the time of sampling.